Technical data

Section 01 ENGINE
Subsection 03 (BOTTOM END)
01-03-2
DISASSEMBLY
The following components should be removed
prior to opening bottom end:
– magneto cover
– magneto flywheel
– starter
1, Seal
If a crankshaft end seal has to be replaced, bot-
tom end must be opened.
2, PTO Flywheel
Lock the crankshaft using the same procedure for
the magneto flywheel removal. Refer to ENGINE
01-01.
Loosen the 6 Allen screws
no. 4
retaining the
coupling flange
no. 3
to the PTO flywheel.
1. Allen screw (6)
Remove the coupling flange
no. 3
.
Loosen bolt
no. 5
retaining the PTO flywheel to
the crankshaft.
1. Bolt
Remove the PTO flywheel
no. 2
using puller
(P/N 290 976 237).
Install puller to PTO flywheel. Insert 6 M8 x 30
screws (P/N 290 940 481) through puller holes
and tighten screws in PTO flywheel to extract it
from crankshaft.
F06D1AA
1
F06D1BA
1
F06B02A
www.SeaDooManuals.net