Specifications

ITEM OPERATION ✓
DESS post and engine
start/stop button
Check operation.
Water flow in exhaust manifold
(only when temperature is
below or close to freezing
point)
Check if water properly flows in exhaust manifold.
NOTE: See the detailed instructions hereinafter.
Hull
Inspect hull for cracks or damage.
Jet Pump Water Intake
Remove weeds, shells, debris or any-
thingelsethatcouldrestricttheflow
of water and damage exhaust cool-
ing system or propulsion unit. Clean
as necessary. If any obstruction can
not be removed, refer to an authorized
Sea-Doo dealer for servicing.
F18J04Y
21
TYPICAL — INSPECT THESE AREAS
1. Water intake
2. Ride plate
Inspect leading edges of the impeller,
if they have nicks or bends, perfor-
mance will be greatly reduced.
Inspect for any possible coolant leak
from ride plate.

WARNING
When operating the engine while
the watercraft is out of the water,
theheatexchangerintherideplate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
Bilge
Should water be present in the bilge,
tilt the watercraft to the rear and un-
screw drain plugs to completely emp-
ty the bilge.
Secure bilge drain plugs.

WARNING
Make sure drain plugs are properly
secured prior to launching the wa-
tercraft in water.
Battery

WARNING
Verify tightness of battery cables to
their posts and condition of battery
retaining fasteners. Do not charge
or boost battery while installed.
Fuel Tank
With the watercraft horizontal, fill the
fuel tank to specified level.
Check fuel tank retaining straps/
fasteners.
68
______________________