Specifications

smo2007-002-007_a
GTI MODELS
1. Oil dipstick
Check the oil level as follows:
NOTE: Before checking the oil level on
this engine, it is necessary to warm-up
engine and to let it idle for 30 seconds
before shutting it off. Thereafter it is
necessary to wait 30 seconds. Then,
the oil can be checked. This is re-
quired to allow the oil to properly lev-
el in the different oil chambers. Oth-
erwise, you will have a false oil level
reading.
– Watercraft must be level. Check oil
level either with watercraft in water
or out of water. Engine should be
warm.
CAUTION: Never run engine with-
out supplying water to the exhaust
cooling system when watercraft is
outofwater.
– If out of water, raise trailer tongue
and block in position when bumper
rail is level. Install a garden hose
to the flushing connector. Refer to
FLUSHING in POST-OPERATION
CARE and follow the procedure.
CAUTION: Failure to flush exhaust
cooling system, when engine is out
of water, may severely damage en-
gine and/or exhaust system.
– Warm-up engine then let idle for 30
seconds before stopping.
– Stop engine.
– Wait at least 30 seconds then pull
dipstick out and wipe clean.

WARNING
Engine oil may be hot. Certain
components in the engine com-
partmentmaybeveryhot. Direct
contact may result in skin burn.
CAUTION: Never run engine longer
than 5 minutes. Drive line seal has
no cooling when watercraft is out of
water.
– Reinstall dipstick, push in complete-
ly.
– Remove dipstick and read oil level.
It should be between marks.
1
F18D2MY
1
2
3
1. Full
2. Add
3. Operating range
– Otherwise, add oil up to have the
level between marks as required.
– To add oil, unscrew oil cap. Place
a funnel into the opening and add
the recommended oil to the proper
level. Do not overfill.
_____________________
63