Specifications

Intercooler and Exhaust
Manifold
The exhaust system is self draining,
but the intercooler and exhaust man-
ifold need the following protection.
Intercooler (if so equipped)
smr2006-012-002_b
TYPICAL
1. Intercooler
2. Exhaust manifold
3. Intercooler outlet hose
4. Engine oil filling cap
Remove both intercooler hoses.
NOTE: Some clamps are removable
and reusable; others must be cut and
replaced.
lmo2007-002-008_a
TYPICAL
1. Intercooler
2. Inlet hose clamp (reusable)
3. Outlet hose clamp (replace)
Let the intercooler drain, then recon-
nect the bottom hose.
By using a funnel and a small hose,
pour approximately 200 mL (6.76 oz
U.S.) of antifreeze into the intercooler
through the outlet nipple.
1
F19D0DA
2
3
TYPICAL
1. Intercooler
2. Outlet nipple
3. Inlet nipple
Reconnect the intercooler top hose
and secure with a new clamp.
Exhaust Manifold
Disconnect the manifold top water
outlet hose from the exhaust pipe.
F18D0IB
1
3
2
TYPICAL
1. Exhaust manifold
2. Exhaust pipe
3. Water outlet hose clamp (reusable)
Install a funnel at the end of water
outlet hose, then pour approximately
300 mL (10.14 oz U.S.) of antifreeze
into the exhaust manifold.
_____________________
115