Specifications

MAINTENANCE

WARNING
Only perform procedures as de-
tailed in this guide. It is recom-
mended that the assistance of an
authorized Sea-Doo dealer be peri-
odically obtained on other compo-
nents/systems not covered in this
guide. Unless otherwise specified,
engine must not be running and
the DESS key must be removed
from its post for all maintenance
procedures. Never use jet pump
components or side vanes to lift
the watercraft. Certain compo-
nents in the engine compartment
maybeveryhot. Directcontact
may result in skin burn. When
operating the engine while the
watercraft is out of the water, the
heat exchanger in the ride plate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
Lubrication
Anticorrosion Protection
Throttle Cable
Lubricate the throttle cable with XP-S
Lube or equivalent.
Throttle Body
Lubricate throttle body with XP-S Lube
or an equivalent.
Use fitting for that purpose provided in
the engine compartment.
Make sure to spray lubricant at least 3
to 5 seconds for proper lubrication.
smo2006-002-026_a
GTI MODELS — TYPICAL
1. Fitting
smo2006-002-025_a
ALL MODELS EXCEPT GTI — ENGINE COVER
1. Fitting
Electrical Connections
As necessary, apply anticorrosion
product such as dielectric grease on
battery posts and all exposed ca
ble
connectors.
Additional Lubrication
XP-S Lube or equivalent will h
elp pre-
vent corrosion of metallic parts and
maintain proper operation of moving
mechanisms.

WARNING
Do not lubricate the DESS post.
106
_____________________