Operating instructions

78
TYPICAL
1. Remove these screws
TYPICAL
1. Push in, twist and remove bulb
The assembly is essentially the reverse
of removal procedures. However, pay
particular attention to the following:
Apply dielectric grease on bulb contact
surface.
Stern Light
Unscrew lens counterclockwise and
pull it out.
1. Unscrew then pull
Pull bulb to remove it.
1. Pull bulb out
Apply dielectric grease on new bulb
contact surface.
The assembly is the reverse of remov-
al procedure.
General Inspection and
Cleaning
Inspection
Check engine compartment for any
damage and the fuel system for leaks.
Also check battery for electrolyte leaks.
Ensure all hose clamps are properly se-
cured and no hose is cracked, kinked or
presenting any other damage.
F09L5FY
1
F09H18Y

WARNING
If at any time, gasoline leaks/odors
are found, do not start the engine.
Have the boat serviced by an au-
thorized dealer.
F04H2UY
1
F04H2VY
1
lmo2004-004b.fm Page 78 Wednesday, August 6, 2003 11:19 AM