Operating instructions

57
PRE-OPERATION CHECKS
Some of the following items may not
have been previously covered in this
guide, however they will be described
in the MAINTENANCE or SPECIAL
PROCEDURES section. Please refer
to these portions to have more de-
tailed information.
SUMMARY

WARNING
The pre-operation check is very
important prior to operating the
vehicle. Always check the proper
operation of critical controls, safe-
ty features and mechanical com-
ponents before starting. If not
done as specified here, severe in-
jury or death might occur. Bring all
safety equipment required by lo-
cal laws.

WARNING
Engine should be off and the safety lanyard must always be removed from
its switch prior to verifying any of the following. Only start craft once all
items have been checked and operate properly.
ITEM OPERATION ✓
Hull Inspect.
Jet pump water intake Inspect/clean.
Bilge Drain. Ensure plug is secured.
Battery Inspect tightness of cables and retaining straps.
Main battery cut-off switch Ensure it is in the ON position.
Navigation lights Check operation.
Fuel reservoir Refill.
Engine compartment Verify fuel/oil system components.
Fire extinguisher Inspect condition/mounting.
Steering Check operation.
Throttle/shifter system Check operation.
Bilge blower and bilge pump Check operation.
Safety lanyard/engine start/stop
button
Check operation.
Mandatory safety boating
equipment
Check operation.
Storage compartment covers Ensure they are closed and latched.
lmo2004-004b.fm Page 57 Wednesday, August 6, 2003 11:19 AM