Operating instructions

47
33) Ventilation Ducts
Located beneath the engine compart-
ment lid, the ventilation ducts supply
air to the engine and ventilate engine
compartment. Ventilation ducts should
never be obstructed.
TYPICAL
1. Ventilation duct
34) Bow/Stern Eyelets
Eyelets can be used for mooring, tow-
ing and as a tie-down point during
transportation.
TYPICAL
1. Stern eyelet
2. Bow eyelet
35) Jet Pump Nozzle
Nozzle turns side to side via input from
the steering wheel. This provides di-
rectional control when engine is run-
ning.
36) Reverse Gate
When selecting the neutral or reverse
position with the shift lever, the re-
verse gate moves up or down to the
desired position.
37) Scupper Valve
This is where water from the deck
drains out. Keep clean to avoid clogging.
TYPICAL
1. Scupper valve
F09L54Y
1
F09L55Y
21

WARNING
Never use gate as a supporting
point to board the craft. Shift lever
should only be used when the en-
gine is idling and craft is complete-
ly stopped.
F09L56Y
1
lmo2004-004b.fm Page 47 Wednesday, August 6, 2003 11:19 AM