Operating instructions

45
Installation
– Lift connector cap.
– Insert post in connector hole. En-
sure to align hole keyway with post
screw head.
– Firmly push downward to engage
terminals.
– Push lock ring downward. Turn until
locked. It may be necessary to
slightly turn it to allow its insertion
in the hole.
– Check light operation. See LIGHT
SWITCH as mentioned earlier in
this section.
TYPICAL
1. Lift
2. Align screw in groove
3. Push downward
4. Turn to lock
CAUTION: Ensure dielectric grease is
present in connector area of light to
prevent corrosion.
27) Mooring Cleats
When mooring to a dock, it is recom-
mended to secure with both front and
rear cleats. The use of dock lines with
sealed air fenders is recommended to
protect your boat.
CAUTION: Never use mooring cleats
to pull anything or to lift the sport boat.
28) Deck
Flat surface of boat, should be kept clean
and clear.
29) Fuel Tank Cap
1. Fuel tank cap
Unscrew the cap counterclockwise to
allow fuel tank filling. Fully tighten when
finished.
1
2
3
4
F04L0LY
F09L52Y
1
lmo2004-004b.fm Page 45 Wednesday, August 6, 2003 11:19 AM