Installation Guide

INSTALLATION INSTRUCTIONS
Silhouette SlimLine
Tub/Shower Seat
LIFESTYLE & WELLNESS ®
LIFESTYLE & WELLNESS®
Patent Pending
Page 5
of 5
Step #5
Tilt the Seat Bottom Panel at
an approximate 45° angle to
tighten the (2) #14 Flat Head
Hex Drive screws located in
Hole #1 (Key-Hole) on both
Seat Mounting Brackets from
the top of the seat, using the
L-Shaped Hex Drive Key
(supplied by manufacturer).
Diagram 4
NOTE:
The Seat Bottom Panel is attached to the aluminum frame at the factory using high-strength VHB tape.
Do NOT attempt to remove the Seat Bottom Panel from the seat frame as it may cause severe damage to the seat.
To ensure proper and safe installation, the Silhouette SlimLine seat should not shift in any direction on the mounting surface.
Hardware Provided: (4) #14 Flat Head Phillips sheet metal screws 2-1/2” length
(2) #14 Flat Head Hex Drive sheet metal screws 2-1/2” length
Tools Provided: Hex L-Key with Standard Tip
Tools Required: Marking pencil/pen, level, masking tape, power drill, 1/4” Carbide tile drill bits, 3/16” Standard drill
bit, #3 phillips driver, silicone.
THIS COMPLETES THE INSTALLATION OF THE SILHOUETTE SLIMLINE TUB/SHOWER SEAT