Installation Guide

INSTALLATION INSTRUCTIONS

GWL-3638 / GWR-3638

Zuma Grab Bar

LIFESTYLE & WELLNESS ®

Page 2

of 2

June 2022

Proceed cautiously through the following steps in this installation process to avoid drilling into in-wall water supply lines.

2. Mounting the Grab Bar.

Step #1

Use a power drill with a 3/32” carbide

tip drill bit (not provided) and drill at

the six (6) locations marked on the

wall into the 2” thick solid wood

in-wall backing.

Step #2

Apply a bead of silicone around the Grab Bar Mounting

Flanges on the mounting surface to ensure a water-tight

seal will be created at all mounting locations. Secure the

grab bar to the wall using six (6) #10 x 2-1/2” stainless steel

screws (supplied by manufacturer) and screw into the 3/32”

holes created in the solid wood backing. Tighten screws

completely after ALL screws are in place. Complete the grab

bar installation by covering the mounting flanges with the

Concealed Flange Covers, snapping them into place.

To ensure proper and safe installation, the grab bar should not shift in any direction on the mounting surface.

Hardware Provided: (6) #10 x 2-1/2” Phillips Pan Head sheet metal screws.

Tools required: Marking pencil/pen, level, power drill, 3/32” carbide tip drill bit, #2 phillips driver, silicone.

THIS COMPLETES THE INSTALLATION OF THIS GRAB BAR.

All mounting points must fasten into structural wood backing, minimum 2” thickness.

Avoid electrical and/or plumbing behind the wall, and where possible drill through tile – not through grout.