Operating instructions

Page 8 of 20
___________________________________________________________________________________________
INSTALLATION INSTRUCTIONS
___________________________________________________________________________________________
UNPACKING
Remove packaging materials.
• Remove and dispose or recycle all packaging
materials.
• Remove tape and glue residue from surfaces
before turning on the air conditioner. Rub a small
amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your air conditioner.
• Handle air conditioner gently.
1. Remove air conditioner from carton and place it
on cardboard.
2. Remove shipping screws from both sides of
cabinet.
3. Remove front panel by removing 2 Phillips
screws on both sides.
4. Remove both knobs from control panel.
5. Remove ground screw and ground wire from
front of air conditioner base. Save ground
screw.
6. Pull on handle to slide air conditioner out of
cabinet. Place air conditioner on cardboard.
NOTE: Do not lift, push, pull or remove any
expanded polystyrene (foam) from inside the air
conditioner. It is not packing material.
________________________________________________________________________________________
WINDOW INSTALLATION (on some models)
NOTES:
• Handle air conditioner gently
• Be sure your air conditioner cabinet does not
fall out of the opening during installation or
removal.
• The location where the power cord exits the air
conditioner should be no more than 4 ft (122cm)
from a grounded 3 prong outlet.
• Do not block the louvers on the front panel.
• Do not block the louvers on the outside of the
air conditioner.
_________________________________________
Attach Top Channel
NOTE: Attach top channel and side curtains to air
conditioner cabinet before placing cabinet in
window.
• Locate supplied bag of screws.
• Place top channel on top of air conditioner
cabinet, lining up the 3 holes in top channel
with 3 holes on top of air conditioner cabinet.
• Using 3 - #10 x 3/8” pan-head Phillips screws,
attach top channel to air conditioner cabinet.