Instruction manual

E-14
Mounting the camera in the Housing
Align the quick lock with the LOCK position to fix the camera
in place
6
7
Align the front case with the rear
case and press them together
8
Close the locking latches
Make sure that the O-ring is properly fitted in the O-ring groove before
setting of the rear case.
See:
“Opening and Closing the Housing” (P.E-10)
After the camera is mounted in the housing, make sure to check that all of
the housing's control parts work properly and the camera functions correctly.
CAUTION
1 Open the locking latches
2 Remove the rear case
3 Set the quick lock to the OPEN position
4 Slide the camera toward you as you remove the front case
Removing the camera from the housing
E-13
Fixing screw
Mounting the Camera in the Housing
Make sure to remove the eyecup from
the camera. If used with the eyecup
in place, it could cause flooding.
Remove the strap or the LCD monitor
cover from the camera, if any of these
accessories are attached.
CAUTION
Rotate the quick lock in the
OPEN direction ( ), and
then remove the quick shoe
from the front case ( )
1
Using the included attachment
tool, fix the quick shoe to the
camera's tripod socket
Make sure the quick lock is in
the OPEN position
4
Align the quick shoe with the
quick shoe base, and slide the
camera fully forward into the
front case
5
2
Attach the lens to the camera,
and then set the focus mode
(AF or MF)
3
To make sure that the gear attached
to the lens and the gear on the front
case do not hit each other, rotate
the focus / zoom dial while sliding
the camera into place.