Installation Guide

1F
1A
2
Install the Fixture
Connect the fixture ground wire to a suitable ground in
accordance with local electrical codes.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Properly place the wires and wire nut connections into
the electrical box.
Use the “UP” label to properly orient the fixture base
and mount it onto the electrical box with two provided
#6-32 screws.
ALLEN WRENCH
SET SCREW
FACEPLATE
If necessary, back out ( ) the set screw ondo not remove
the side of the faceplate using the provided Allen
wrench.
Install the faceplate onto the fixture base and tighten
the set screw with the provided Allen wrench.
Required for wet location installation only; install the
gasket onto the back of the fixture base.
GASKET
FIXTURE
BASE
1B
2
1
3
4
4
3
2
5
6
5
6
9
10
UP
Install the double-sided tape onto the back of the
faceplate as shown. NOTE: Press firmly on the double-
sided tape to ensure it is properly stuck on the
faceplate.
DOUBLE-
SIDED TAPE
FACEPLATE
Install the insert into the faceplate and secure it in place
by pressing it firmly against the double-sided tape.
DOUBLE-
SIDED TAPE
FACEPLATE
INSERT
1E
1D
7
8
7
7
8
1C
6
6
UP
UP
6
6
HORIZONTAL MODEL VERTICAL MODEL