SDS

Applicable Law: USA
Page 3 of 7
Sea Foam Sales Company
510 North Chestnut Street
Chaska, MN, USA 55318
Sea Foam Motor Treatment
SDS Revision Date: 10/16/2019
SAFETY DATA SHEET
SECTION 6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
: All persons dealing with clean-up should wear the appropriate protective equipment including
self-
contained breathing apparatus. Keep all other personnel upwind and away from the
spill/release. Restrict access to area until completion of clean-up. Refer to protective
measures listed in sections 7 and 8.
Environmental precautions
: Do not allow material to contaminate ground water system. If necessary, dike well ahead of
the spill to prevent runoff into drains, sewers, or any natural waterway or drinking supply.
Methods and material for containment and cleaning up
: Ventilate the area. Remove all sources of ignition. Prevent further leakage or spillage if safe
to do so. Use only non-sparking tools. Soak up with inert absorbent material. Do not use
combustible absorbents, such as sawdust. Pick up and transfer to properly labeled
c
ontainers. Contaminated absorbent material may pose the same hazards as the spilled
product. Contact the proper local authorities.
Special spill response procedures
: If a spill/release in excess of the EPA reportable quantity is made into the environment,
immediately notify the national response center in the United States
(phone: [phone]).
US CERCLA Reportable quantity (RQ): None.
SECTION 7. HANDLING AND STORAGE
Precautions for safe handling
: Obtain special instructions before use. Do not handle until all safety precautions have been
read and understood. Wear protective gloves and eye/face protection. Use only in well-
ventilated areas. Avoid breathing vapor or mist. Avoid contact with eyes, skin and clothing.
Keep away from heat, sparks and open flame. - No smoking.
Ground/Bond container and receiving equipment. Take precautionary measures against
static discharges. Use explosion-proof ventilating equipment. Keep container tightly closed.
Do not eat, drink or smoke when using this product. Empty containers retain residue (liquid
and/or vapor) and can be dangerous. Wash thoroughly after handling.
Conditions for safe storage
: Store in a cool, dry, well-ventilated area. Store locked up. Storage area should be clearly
identified, clear of obstruction and accessible only to trained and authorized personnel. No
smoking. Protect from sunlight. Have appropriate fire extinguishers and spill clean-up
equipment in or near storage area.
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Limits:
Chemical Name
ACGIH TLV
OSHA PEL
TWA
STEL
PEL
STEL
Hydrocarbon blend
5 mg/m³ (inhalable
fraction, mineral oil
mists)
N/Av
5 mg/m³ (As 'Oil
mist, mineral')
N/Av
Isopropanol
200 ppm
400 ppm
400 ppm ; 980
mg/m³
N/Av
Exposure controls
Ventilation and engineering measures
: Provide mechanical ventilation in confined spaces. Use explosion-proof equipment.
Respiratory protection
: If the TLV is exceeded, a NIOSH/MSHA-approved respirator is advised.
Skin protection
: Impervious gloves must be worn when using this product. Advice should be sought from glove
suppliers. Wear long sleeved shirt and pants to minimize exposed skin.
Eye / face protection
: Chemical safety glasses with side shields or splash proof goggles. A full-face shield may also
be necessary.
Other protective equipment
: Depending on conditions of use, an impervious apron should be worn. An eyewash station
and safety shower should be made available in the immediate working area.
General hygiene considerations
: Avoid breathing vapor or mist. Avoid contact with eyes, skin and clothing. Do not eat, drink or
smoke when using this product. Wash thoroughly after handling. Remove and wash
contaminated clothing before re-use. Handle in accordance with good industrial hygiene and
safety practice.