SDS

SAFETY DATA SHEET Sea Foam Concentrated Fuel injector Cleaner
Revised: 4/18/2019 Page 5
Clothing: Use neoprene or nitrile gloves. When handling at elevated
temperatures, use insulated apron or coat. Launder
contaminated clothing before reuse
Hygiene: Wash thoroughly after handling this product.
9. Physical and Chemical Properties
Appearance Pale yellow liquid
Odor Petroleum
Odor threshold Not determined
pH Not determined
Melting Point Not determined
Initial Boiling Pt/Rng Not determined
Flash Point > 93°C / 199°F (estimated based on components)
Evaporation Rate Nil (where nBuAc = 1)
Upper Flammable Lm Not determined
Lower Flammable Lm Not determined
Explosive Data Not determined
Vapor Pressure 0.013 torr @ 25°C / 68°F
Vapor Density Not determined
Volatile Organics Not determined
Density 0.9 mg/cu. cm @15.6°C
Solubility Insoluble in water, alcohols; soluble in organics
K
ow
Not determined
Viscosity Approximately 20mm/s
2
@ 40°C
Autoignition Point Not determined
Decomposition Temp Not determined
Specific Gravity 0.9
10. Stability and Reactivity
Stability Material is normally stable at normal temperatures and
pressures
Decomposition Temp Not determined
Incompatibility Oxidizers and reducers
Polymerization Will not occur
Thermal Decomposition Smoke, oxides of carbon, sulfur and nitrogen
Conditions to Avoid Keep away from heat, flames, strong oxidizers and strong
reducing agents
11. Toxicological Information
- Acute Exposure –