User`s manual

Table Of Contents

Section 6: Configure Outputs

This section describes the setup of the following in Configure Outputs:

• Serial data output

• Serial ports

• Shared file output

• Mark variables

• TCP/IP output

• TCP/IP ports

• SBE 11plus alarms (only applicable if instrument configuration [.con] file

is for 911plus/917plus CTD)

• SBE 14 Remote Display

• Header form

• Diagnostics

Some outputs – serial data out, shared file out, SBE 11plus alarms, and

remote display - can be reconfigured during data acquisition without

interrupting data acquisition. For example, if you start a cast and realize that

you forgot to set up the serial data output, you can select Configure Outputs,

and make and save the desired changes, all without interrupting the data

acquisition. Once the desired changes are saved, the serial data will begin to

output to the desired COM port (of course, any data that was acquired before

you modified the setup will not be output in the serial data stream).

For setup of the inputs, see Section 3: Configure Inputs, Part I - Instrument

.con File, Section 4: Configure Inputs, Part II – Calibration Coefficients,

and Section 5: Configure Inputs, Part III – Serial Ports, Water Sampler,

TCP/IP Ports, Miscellaneous, and Pump Control.

Note:

Setup of all parameters (except

Diagnostics) in Configure Outputs

is included in the SEASAVE

program setup (.psa) file. To save

the setup, you must save the .psa

file (File menu / Save Setup File)

before exiting SEASAVE.