User`s manual

Manual revision 016 Index SBE 49
72
Appendix VI: Manual Revision History
Manual
Version
Date Description
002
10/01
• Initial release production units.
003
12/02
• Add information on pressure output format in decibars.
• OutputFormat=2&3: Add information that leading 0’s suppressed.
• Correct OutputFormat=2 description: temperature tttttt (not tttttttt), strain pressure pppppp (not
pppppppp), strain T compensation v.vvvv (not vv.vvvv).
• Correct pressure sensor calibration fitting, add pressure sensor maintenance information.
• Anti-foul replacement: use EPA-approved description.
• Add information on baud rate and sampling time and cable length.
• Add more information pump operation details.
004
01/03
• Add AF label pages in appendix.
005
01/03
• Add information on mechanical design change of TC duct/anti-foul cup and cap.
006
03/03
• Add compatibility with Seasave.
007
08/03
• Update description of output format required for data to be processed by SBE Data Processing.
• Update to allow use of SBE 36 & PDIM with SBE 49.
• Add information on TC duct.
• Update for 9 pin computer connections.
• Correct Baud=: 600 baud is not valid with SBE 49.
008
07/04
• Firmware 1.2:
-- Add commands to align, filter, and apply thermal mass correction in real-time so computed
salinity and sound velocity are correct.
-- Remove PType=..
-- Add SetDefaults.
• Remove optional 12-28 VDC range from specifications.
• Add plastic housing option.
• Update power specifications and power and cable length information.
• Update Seaterm screens to correspond to Seaterm versions 1.40 and later.
• Correct conductivity sensor calibration range to 2.6 – 6 S/m plus zero conductivity.
009
08/05
• Update exhaust information: straight exhaust standard, tee exhaust in spares kit that ships with 49.
• Add 600 m pressure sensor to list of available sensor ranges.
• Update conductivity cell cleaning procedure to be consistent with application note 2D.
• Add more info about triton.
• Add information that pump does not run automatically for testing commands (TC, etc.).
• Update connector to MCBH with water block.
• Update AF24173 Anti-Foulant Device appendix to current label.
010
07/06
• Change specification for plastic housing to 250 m from 350 m.
• Update Triton website link.
• Update pressure port maintenance, Sea-Bird no longer filling with silicon oil.
• Add information that can use SBE 49 with SBE 32 Carousel (with serial interface) and SBE 33
Deck Unit.
• Update recovery warning, providing more detail.
• Correct information on real-time data corrections.
011
05/07
• Incorporate Seasave V7.
• Update .con file screen capture to show ‘scan time added’ field in SBE Data Processing and
Seasave.
• Add information that can use SBE 49 with SBE 55 ECO Water Sampler and SBE 33 Deck Unit
• Add more information on deployment recommendations.
Continued on next page