User`s manual

Section 4: Configure Menu, Part II - Instrument .con File
43
Old Style SBE 21 Thermosalinograph Configuration
Time between scans.Used to
calculate elapsed time, if you select
time as a parameter for a display
window. For calculation to be correct,
this entry must agree with number
programmed into SBE 21 with SI
command; see reply from status
command (DS).
Select if using with a deck unit
connected to a NMEA navigation
device. If selected, SEASAVE
automatically adds current latitude,
longitude, and universal time code to
data header. Select NMEA (Lat/Lon)
Interface in SEASAVE’s Configure
menu to control how Lat/Lon data is
incorporated.
Listing of channels at bottom of
dialog box reflects this choice
(0 or 1). Must agree with XY or XN
command programmed into SBE 21
to enable or disable external
frequency (temperature) sensor; see
reply from status command (DS).
If external frequency is enabled,
SEASAVE (and Data Conversion
and Derive in SBE Data Processing)
uses remote temperature data
when calculating density and
sound velocity.
Click to modify list of sensors (after number
of frequency channels and voltage words
have been specified above). Data Format
Definition dialog box with a list of sensors
appears. Select sensors.
Click to return to Examine / Change
Instrument Configuration File dialog
box. In that dialog box, click Change
Calibration Coefficients to view,
modify, or enter coefficients.
Listing of channels at
bottom of dialog box
reflects this choice. Must
agree with number
programmed into SBE 21
with SVn (n= 0, 1, 2, 3,
or 4) command; see reply
from status command
(DS). Voltage channel 0 in
.con file corresponds to
sensor wired to channel 0
on end cap connector,
voltage channel 1 in .con
file corresponds to sensor
wired to channel 1 on end
cap connector, etc.