User`s manual

Section 4: Configure Menu, Part II - Instrument .con File
37
C. After completing instrument configuration, click Change Calibration
Coefficients (in the Examine / Change Instrument Configuration File
dialog box) to change or enter sensors’ serial numbers, calibration
dates, and/or calibration coefficients. The Change Calibration
Coefficients dialog box appears, with a list of the sensors you defined
for the configuration in Step 4B:
Double click on a sensor to bring up its calibration coefficient dialog
box. An example is shown below for a pH sensor:
Enter or modify the information in the dialog box, and click OK.
D. In the Change Calibration Coefficients dialog box, click OK when
done entering / modifying calibration coefficients for the sensors.
E. In the Examine / Change Instrument Configuration File dialog box,
click Save [.con] File.