User`s manual

Section 3: Configure Menu, Part I - General System Setup
15
Remote Display Alarm
The SBE 14 Remote Display can be set up to turn an alarm on when pressure
is less than and/or more than a specified amount.
To enable and set up the Remote Display Alarm:
1. In the Configure menu, select Remote Display.
2. In the Remote Display Configuration dialog box, select Send Data to
SBE 14 Display. Make other selections as desired (see Remote Display
below), and click OK.
3. In the Configure menu, select Alarms / Remote Display Alarm. In the
Remote Display Alarm Configuration dialog box, select the desired alarm
(minimum pressure alarm and/or maximum pressure alarm) and enter the
alarm setpoints in decibars. Click OK.
Note:
Remote Display alarm setup in
SEASAVE is applicable only for
an SBE 14 connected to a
computer COM port. If the
SBE 14 is connected directly to
an SBE 11plus Deck Unit,
Remote Display alarm setup is
done by sending commands to
the SBE 11plus using SEATERM.