Manual
Reexion Filter Technical Manual
1. Remove the Reexion Filter and stand assembly unit from the
packaging. Please keep the packaging safe to store the
Reexion Filter when not in use, or for transportation. It
is robust, but parts may get damaged or lost in transit if not
packaged properly.
You should have the following parts – Reexion Filter (curved
wall), stand assembly, support rod and spanner to t support
rod.
2. Fix the stand clamp assembly in place on the neck of your
microphone stand a few inches below the point where the
shock mount is usually xed, or on the main vertical support
strut of the stand.
You’ll see the assembly has a metal block with two large
screws and a handle on it (one of the screws has a spring to
help lock the assembly rmly onto the mic stand.
Mic stand booms vary in diameter so you’ll need to
experiment to get the clamp just right, but basically you
need to set the screw with the spring so the two parts of the
clamp sit parallel to each other, and then tighten the clamp
using the larger screw.
Assembling Your Reexion Filter