sE Electronics DynaCaster
 I
t’s the pricey, large-diaphragm 
studio condenser mics that get 
many of us drooling with lust, 
but the fact is, most of us have 
to make do with a less 
expensive dynamic mic.
However, in many recording 
scenarios, the lowly dynamic mic is 
the better choice. It may not have the 
broad frequency response or impart 
quite the same level of clarity as a 
condenser, but it’s more robust, way 
better at rejecting unwanted room 
noise and can brush off epic SPL 
levels with impunity. Consequently, 
dynamic mics like the DynaCaster are 
perfect for recording voice and vocals 
in untreated rooms (that’s most home 
studios), screamers, guitar cabs, 
drums and much, much more.
The only fl y in the ointment is that 
the best dynamic mics devour clean 
gain like there’s no tomorrow. 
Until recently, the only solutions 
were to buy a pro-level interface/
preamp or a Cloudlifter, but now the 
preamp-equipped DynaCaster is a 
truly nifty alternative that begs the 
question: why aren’t all dynamic mics 
built this way?
The DynaCaster is a dynamic 
end-address cardioid broadcast-style 
mic hiding a potent trick up its 
sleeve. It’s a little stubbier than an 
Electro-Voice RE-20 or a Shure 
SM7B but its all-metal construction 
and solid build gives it a reassuringly 
weighty feel. Drop this thing and your 
toes will come off worse.
The design is beautifully 
executed. The engineers at sE have 
invested a lot of time ensuring the 
integrated swivel mount will attach to 
virtually any mic stand or boom arm, 
slightly differently, providing a fl at 
setting plus two levels of boost.
Essentially, used in combination, 
these controls enable you to fi ne-tune 
the mic to its surroundings, your 
talent or both. The inclusion of these 
tone-shaping tools, the built-in 
preamp and the DynaCaster’s 
relatively compact size make it a 
superb choice for producers on the 
move, who are often tasked with 
recording unknown talent in unseen 
rooms using unfamiliar equipment.
Perhaps it’s our room, but the only 
setting we didn’t warm to was the 
high-level top boost, which sounded 
too thin, too harsh and did little other 
than emphasise sibilance. Still, this is 
a very clever dynamic mic capable of 
nailing the right sound, even in less 
than perfect conditions when you’re 
forced to use lower grade kit.
Calling it a broadcast mic is 
selling it short. Whether you’re a 
producer, vocalist, podcaster or 
simply need to mic up some guitar 
cabinets, the DynaCaster deserves 
your attention. 
making it a doddle to set up. It’s also 
easy to clean the built-in, three-layer 
removable pop-fi lter/windscreen. 
Its custom aluminium voice 
coil-equipped capsule, which is 
suspended in an integrated shock 
mount, is similar to the one you’ll fi nd 
in sE’s well-respected V7 hand-held 
mic but it’s been fettled to elevate the 
DynaCaster up a notch or two.
Make no mistake, even in passive 
mode the DynaCaster is a fantastic 
dynamic mic that’s more than 
capable of giving any high-end 
competition a run for its money. Its 
frequency response curve is almost 
fl at, albeit slightly boosted, from 
200Hz right up to 10kHz, with a 
gentle low-end roll-off and more 
pronounced high-end roll-off. 
Sure enough, it’s an authentic mic 
to record with, one that rejects 
low-end rumble and doesn’t suffer 
from undue top-end harshness. It’s 
well suited to voice applications but 
can handle pretty much anything.
The magic really happens when 
you play with the three switches 
around the back. Fire up phantom 
power on your interface, activate the 
centre switch and the DynaCaster’s 
built in Dynamite preamp will deliver 
an impressive +30dB of clean gain. 
This amount of boost is more than 
enough to get you noise-free 
recordings, and we noticed that it 
provided a slightly fuller sound too.
Either side of the boost switch are 
two three-way tone shaping switches, 
a low frequency trim and a high 
frequency trim. The low end can be 
left fl at, boosted to provide extra 
warmth or cut to eliminate boominess 
and rumble. The high-end trim works 
THE PROS & CONS
+
 Built-in  preamp 
provides a 
considerable amount 
of clean gain  
F abulous  tone 
shaping tools and 
very versatile 
 Small form factor 
and built-in preamp, 
great for travel  
-
Less seductive if you 
already own a 
high-end interface 
or preamp
FM VERDICT
 9.6
 Easy to fall in love with. The 
addition of a quality preamp 
is a masterstroke that makes 
it a powerful solution  for a 
range of uses
sE Electronics DynaCaster | Reviews
81
FMU387.rev_se2.indd 81FMU387.rev_se2.indd 81 08/08/2022 15:4308/08/2022 15:43


