Specifications

7. Maintenance schedule
7.1. Reminder of use
The maintenance interval frequency and the operations to be carried out are outlined in the maintenance schedule, given as a guideline.
N.B. the environment in which the generating set is operating determines this schedule.
If the generating set is used in extreme conditions, shorter intervals between maintenance procedures should be observed
These maintenance intervals only apply to generating sets running on fuel, oil and coolant which conform to the specifications given
in this manual.
7.2. Engine
R = Replace
I = Inspection (includes, if necessary, cleaning, adjustment, lubrication and charge)
First service inspection
After the first 100
–
200 hours
Fuel pre-filter, draining water / contamination I
Coolant level I
Drive belts I
Start and warm up engine
Coolant / oil / fuel, leakage I
Inspection with VODIA (diagnostic tool) I
Engine and transmission, abnormal noises I
Stop engine
Engine oil and oil filters / by-pass filter R
Restart engine
Oil pressuer / oil leakage I
Every 50 – 600 hours
At least every
(month)
12 24 48
Engine oil and oil filters / by-pass filter R

After the first 1 000 hours
Valve clearance I
Every 500 hours
At least every
(month)
12 24 48
Fuel tank (sludge trap), drain R

Inspection with VODIA (diagnostic tool) I

Fuel pre-filter, draining condensed water I

Air filter inserts (indicator), engine I

Radiator I

Drive belts I

Batteries, electrolyte level I

Every 1 000 hours
At least every
(month)
12 24 48
Fuel filter R

Air filter insert R

Fuel pre-filter R

Coolant filter (if fitted). Not at same time as coolant change. R

Every 2 000 hours
Valve clearance I
Every 2 000 hours
At least every
(month)
12 24 48
Turbo I

Turbo, Wastegate I

Engine, with respect to leakage I

Engine hoses, cables and clamps I

Engine, cleaning and painting I

Air filter, tank breather R

Air filter compressor R

117/285