Product data

Chapter 14. Service and support 365
14.9 Guided Repair
You can perform Guided Repair procedures from the context menu of a
managed system. Right-click a server and select Service and Support. The
Guided Repair tasks are listed under two menus: Hardware and FSP Failover.
Guided Repair is also referred to as Repair and Verify (R&V).
Here are the common Repair and Verify procedures:
Add or Remove FRU
Displays a list of Field Replaceable Units (FRUs) that can be added
or removed from the managed system. Select the FRU that you want
to add or remove and Guided Repair guides you through the
procedure.
Add or Remove Enclosure
Displays a list of FRUs that can be added or removed from the
managed system. Select the FRU that you want to add or remove
and Guided Repair guides you through the procedure.
Open or Close MES
Displays a list of MES numbers. You can create a new MES number
entry in the Order MES page. You can close or end a MES number
by selecting and clicking Next in the Close MES page.
Exchange FRU
Displays a list of FRUs that can be exchanged with replacement
FRUs. Select the FRUs to exchange and Guided Repair guides you
through the procedure.
Setup FSP Failover
Enable or disable FSP failover on managed systems with more than
one FSP.
Initiate FSP Failover
Fails over FSP control from the primary to secondary FSP.
Power On/Off Unit
You can power on or power off the unit or PCI slot from the displayed
tree of I/O drawers.
Prepare for Hot Repair/Upgrade
Select the component using the location code of the system to be
repaired. After selecting the component, SDMC provides a summary
of required actions to be performed to isolate a particular hardware
component as part of a service procedure.