Product data
282 IBM Systems Director Management Console: Introduction and Overview
The output of the Power Systems management commands on the SDMC is the
same as it used to be on the HMC, as shown in Example 10-3.
Example 10-3 SDMC command output
sysadmin@sdmc2:~> smcli lssyscfg -r sys -F name,state
p570_170,Operating
POWER7_1-061AA6P,Operating
p570_6A0,Operating
sysadmin@sdmc2:~> smcli lshwres -r virtualio --rsubtype fc --level sys
-m p570_6A0
num_wwpns_remaining=65496,wwpn_prefix=C0507600096A
For nearly all Power Systems management commands, there is a man page that
can be accessed by running man command name or man psm.command name.
There are two new commands introduced in SDMC:
impdata
mk5250
You can find a description of them in “IBM Power Systems management
commands” on page 368.
10.2 HMC commands supported on the SDMC
Table 10-3 lists the HMC commands supported in the SDMC along with their
purpose and details about what has changed, if anything, for each command in
the SDMC. For the syntax of these commands, refer to the man pages or go to
the following address:
http://www14.software.ibm.com/webapp/set2/sas/f/hmcl/resources.html
There are some commands that are not listed at the website for the HMC. You
can find these commands in “IBM Power Systems management commands” on
page 368.
Table 10-3 HMC commands supported at the SDMC
HMC command Usage of command Changed
asmmenu Launches the Advanced Systems
Management Interface (ASMI) for a
managed system using the browser on
the SDMC.
This command must be run without the
smcli prefix.