Product data

Chapter 7. Firmware updates 125
6. From the Start Target Checks page, initiate readiness and concurrency
checks for the selected targets. These checks can take a few minutes
depending on the number of targets selected. Click Next to continue. The
Target Check Results page (shown in Figure 7-16) opens and shows the
results of the checks.
An Information message box at the top of the page also shows the estimated
time for the selected update task to complete. Here the user also selects
whether to auto-accept the current firmware level on the temporary side of the
FSP. Accepting this image copies the contents of the temporary FSP side to
the permanent FSP side. Additionally, if the update is disruptive, the user is
given the choice to either concurrently install with deferred activation or
disruptively install and activate.
Figure 7-16 Target Check Results page
7. On the Show Needed Updates page, click the Install... button that becomes
available. The Task Launch dialog box opens, which allows you to run the
installation task now or to schedule it for later. Click OK to run the task now
and the Active and Scheduled Jobs page opens and show the task progress.
The status shows as Complete after the installation operation has been
successfully run.