User's Manual

20
4.4.3 DHCP Settings
This page allows you to configure eMTA LAN DHCP configuration, the configuration is described below.
Items Description
Status
DHCP function switch.
You can enable or disable the DHCP function here. The default is to enable it.
Start Address
Start address of the DHCP address group.
Here you can configure the starting address of the LAN DHCP address
group. Only the last one can be edited, and this address cannot be duplicated
with the LAN address .
End Address
End address of the DHCP address pool.
You can set the end address of the LAN DHCP address pool here. Only the
last address can be edited. This address cannot be duplicated with the LAN
address and must be greater than the start address.
Lease time
DHCP rental time.
Here you can configure the DHCP lease time. The unit of time is
minutes. The range of settings is from 1 to 10,080 minutes .
DNS Relay
DNS relay function.
You can enable or disable the DNS relay function here. By default, it is
disabled.
When activated, the DNS address acquired by the EMTA CPE is the EMTA