User's Manual

LISTENING TO AUX DEVICES
1. Connect a standard audio cable with 3.5mm plug to the headphone or
line-out jack on your AUX device and the other end to the AUX IN jack
located on the back of the iZBT10.
2. Press and release the Power Button to turn on the unit.
3. Press and release the Mode Button as needed to cycle to AUX mode,
indicated by AUX-IN on the display.
3. Turn on your AUX device and use its controls to play, pause and navigate
audio tracks. Adjust the volume on your AUX device to maximum output.
4. Press the or Button on the unit to adjust the system volume. Press
the Button to mute aux audio, and again to unmute.
5. Press and release the Power Button to turn o the unit when through
listening. Remember to turn o your AUX device, too.
CHARGING DEVICES VIA USB PORT
A 1 Amp USB port is located on the back of the unit for charging devices
while the unit is connected to AC power. Connect one end of a compatible
USB cable (not included) into the standard USB port on the unit and the
other end into the device you wish to charge. Some devices require higher
amperage USB charging ports. Monitor the charging status of your
device. If the device does not charge, you will need to use the charger
that came with your device.
13
Mobile Phone
Game Devices
iPod
Laptop
PC/Tablet
MP3/MP4
AUX-IN
DC12V 2.5A