User's Manual

Setting the Clock

This unit has a Daylight Saving Time (DST) Switch located under the battery compartment

door. By default it is set to Auto and will automatically adjust the clock at the start and end of

daylight saving time. If your location does not observe daylight saving time, move the switch

to the -1 position before setting the clock.

1. Press and hold the Sleep/Clock Adjust Button for 2 seconds until the clock

display ﬂashes and a beep sounds.

2. Press the or Buttons to adjust the clock to the current time (hold for

rapid setting). Make sure you set the correct AM/PM time. The AM and PM

indicators appear to the left of the display.

3. Press the Sleep/Clock Adjust Button to conﬁrm the time. The year will ﬂash on the display.

4. Press the or Buttons to adjust the clock to the current year (hold for

rapid setting).

5. Press the Sleep/Clock Adjust Button to conﬁrm the year. The date and month will ﬂash on

the display.

6. Press the or Buttons to adjust the clock to the current date and month

(hold for rapid setting).

7. Press the Sleep/Clock Adjust Button to conﬁrm the date and month and exit clock setting

mode. 2 beeps will conﬁrm clock setting is complete.

TIP: To toggle the clock display between standard 12 hour time and 24 hour (“military”) time

display, press the Alarm Button or Alarm Button while the display is ﬂashing during

clock setting.

Setting and Using the Alarms

This unit features dual alarms which can be set to dierent times and alarm sources. Each is set

in the same way. Instructions are given as “Alarm Button”; use Alarm Button or Alarm

Button to set respective alarms.

Note: Each step must be completed while display is ﬂashing or step will time-out with any

changes saved.

Using the iWBT400

3/01/2017