User's Manual

6. If pairing is successful, “BT” will appear at the bottom of the display, the Bluetooth icon

will appear solid and 2 beeps will sound, indicating the iWBT400 is ready to play

music. There should also be an indication on your device. If no device is successfully

paired within 2 minutes the iWBT400 will default to previous mode. Once the iWBT400

is paired to a device, it will attempt to autolink when the device is within range (about

33 feet). To clear paired Bluetooth devices from the unit, press and hold the

Play/Pause/Pairing Button for 10 seconds.

P12

Whenever AC power is connected, the iWBT400 will attempt to autolink to a previously

paired device. If no device is paired, the iWBT400 will automatically enter pairing mode for

2 minutes. For manual pairing, follow steps below.

1. Make sure your Bluetooth device (audio source) is turned on with

Bluetooth mode enabled (check in the device’s Settings).

2. Press the Power/Alarm Reset Button to turn on the unit.

3. Press the Mode Button to cycle to Bluetooth mode, indicated by “BT”

on the display.

4. Press and hold the Play/Pause/Pairing Button for 2 seconds. The

iWBT400 will beep and “PAIR” and the Bluetooth icon will ﬂash on

the display, indicating the iWBT400 is in pairing mode.

5. “iHome iWBT400” should appear in your device’s Bluetooth menu.

Select “iHome iWBT400” to connect it. If prompted for a passcode,

enter “1234” on your device’s keypad.

Using the iWBT400

Pairing Your Bluetooth Device

pair

iHome iWBT400