User's Manual

aux-in iPod dock
network setupstatus
12V 3A
network setup
status
5
English
Power
Quick Start
Connect to power source
1
Press & hold power button
(3 seconds) to power unit ON.
2
AirPlay Wireless Audio Mode
Select the iHome iW2 as your AirPlay
audio speaker
4 5
2
iPod Local Audio Mode
Press for iPod mode
1 2 3
Dock iPad/iPhone/iPod using iPod USB sync
cable
(iPod and aux-in play in parallel)
Press buttons on the iW2 or
iW2 remote, in iPod mode, to control
your iPod music.
Press buttons to adjust volume.
Note: Use iPod mode for both iPod
docking and Aux-in audio playback.
AirPlay Wireless Audio Mode (visit pages 8-9 for Wi-Fi network configuration)
Press for AirPlay wireless mode
1 2 3
Verify that your iW2 speaker is successfully
connected to your Wi-Fi network.
(visit page 8 for connecting your iW2 speaker to your
Wi-Fi network)
Press buttons on the iW2 or
use your iTunes, iPad, iPhone, or iPod
touch controls directly.
Press buttons to adjust volume
or control volume on your AirPlay
source device.
Look for the AirPlay logo
to select your speaker
Launch iTunes or use your iPad, iPhone,
iPad touch. Verify iW2 and AirPlay source
device is on same Wi-Fi network.
!
Note: for AirPlay streaming:
iPad, iPhone, and iPod touch support
point-to-point audio streaming to one
AirPlay enabled speaker.
iTunes supports point-to-multipoint audio
streaming to up to three AirPlay enabled
speakers (performance depends on your
Wi-Fi network and environment).
AirPlay only works with iPod touch, iPhone, iPad,
or iTunes (Mac or PC)
Connected Not Connected
iHome iW2 speaker
aux-in iPod dock
network setupstatus
12V 3A
aux-in iPod dock
network setupstatus
12V 3A
network setup
status
aux-in iPod dock
network setupstatus
12V 3A
12V
outlet
Press repeatedly to cycle between
standby and ON.
Press & hold (3 seconds) to activate
power save mode and reset the iW2.
Note: When the iW2 is in power save
mode, you must press & hold to begin
using your iW2 speaker.
3
allow 10 seconds to allow system to startup