User's Manual

Listening to Radio

Listening to iPod

1. Dock an already playing iPhone or iPod (always use proper insert, see table on page 2). The iP47 will auto-

matically turn on and you will hear the audio playing from your iPhone/iPod. Note: If the audio source

volume is too low on the iPhone/iPod, the iP47 may not detect that the iPhone/iPod is in play mode. If so,

pressing the Alarm Reset/Power Button on the main unit once should make it play.

2. When the iPhone/iPod is docked and in standby mode, press the Play/Pause Button on the main unit or

remote to play the iPhone/iPod. If the iP47 is already on, press the Mode Button until “iPod” appears on

the lower part of the display, indicating the iP47 is in iPod mode.

3. Press the Play/Pause Button on the iP47 or on the remote control remote to pause play; press again to

resume play.

4. Press the Raise Volume or Lower Volume Button on the iP47 or on the remote control to adjust the system

volume.

5. Press the Mute Button on the remote to mute the iP47 output. Press the Mute Button again (or a volume

button) to release mute and restore normal sound output.

6. Press UP or DOWN Set Button on the iP47 or on the remote control to go to the next or previous track.

Press and hold while track is playing for high speed forward or reverse music search of the current track.

Setting up the Antennas

1. Connect the AM loop antenna plug to the back of the unit; adjust the antenna as needed for best reception.

2. Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

1. Press the Mode Button until the desired radio band appears: FM1, FM2 or AM.

2. Press the UP or DOWN Set Button to tune the radio to a desired station. Hold a Set Button briefly to have

the radio autoscan/ search for the next clear station.

3. To memorize the current station as a preset, press and hold Preset Button 1, 2, 3 or 4. A beep will confirm

the setting and the preset number will appear in the display. Repeat steps 1-3 to preset up to 12 stations

(8 FM and 4 AM and). To listen to a preset station at any time, simply press the desired preset button. To

change presets, select your radio band, tune to the desired station and press the preset button.

4. Press the Raise Volume or Lower Volume Button on the iP47 or on the remote control to adjust the system

volume.