User's Manual

Using the iP47

Connecting the iP47 to Power Source

Connect the AC adaptor cable plug into the jack on the back of the system, then plug the AC cord of the AC adaptor into

the wall outlet.

Turning the iP47 ON or OFF

Press the Power Button on the iP47 or on the remote control at any time to turn the iP47 On or Off. Note that

a docked iPhone or iPod will continue to charge when the unit is turned off as long as the AC adaptor is plugged

in.

Setting Up the iP47

The iP47 clock is preset to U.S. Eastern Standard Time. It is simple to adjust the unit for your location.

1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch

located on the back of the unit to +1 to add one hour or to -1 to subtract one hour.

2. Press and hold the Time Zone Button located on the back of the unit until Time Zone Indicator at the lower

part of the display flashes. Press the UP or DOWN Set Buttons to select your time zone.

3. Press Time Zone Button again. You will hear two beeps confirming your setting and exit the Time Zone

Setting mode.

4. If the time showing is not correct, please see Setting Time and Calendar below to set the clock.

Setting Time and Calendar

1. Press and hold the Clock Adj Button located on the back of the unit for 2 seconds until the hour display

flashes. Press the UP or DOWN Set Button to adjust the hour. Hold a set button for a few seconds to

advance or reverse rapidly. Remember to set the correct AM or PM hour. An icon in the upper right hand

corner of the time display is the PM Indicator; there is no AM indicator.

2. Press the Clock Adj Button again. The minute display will flash. Press the UP or DOWN Set Button to adjust

the minute setting. Hold a set button for a few seconds to advance or reverse rapidly.

3. Press the Clock Adj Button again. The year will flash in the lower part of the display. Press the UP or

DOWN Set Button until the current year is displayed.

4. Press the Clock Adj Button again. The number of the month will flash. Press the UP or DOWN Set Button

until the current month is displayed.

5. Press the Clock Adj Button again. The date will flash. Press the UP or DOWN Set Button until the current

date is displayed.

6. Press the Clock Adj Button once more. Two beeps will sound to confirm your settings and you will exit Time

and Calendar Setting mode.