User's Manual

Listening to Bluetooth Music

Listening to other portable audio devices

P10

You need to pair your Bluetooth device with the iP47 before you can play/stream Bluetooth music through the

iP47. Pairing creates a permanent “bond” so two devices can always recognize each other. Note: the iPhone

does not support the A2DP protocol, so it cannot be used to stream music. See Listening to your iPhone to

play your iPhone through the iP47. DO WE NEED TO ADD LINKING INFO?

Pairing:

1. Press and hold the Play/Pause Button for 4 seconds to begin pairing operation. The Bluetooth and “pairing”

icons will flash.

2. Activate Bluetooth on your device according to the device’s user manual to link to iP47 . You may need to

input the iHome device pass code: “1234”.

3. Once connected, the Bluetooth Icon will remain.

4. iP47 will auto pair a paired device next time.

Playing Bluetooth Music:

1. Once your device and the iP47 are paired you can start to play Bluetooth music through iP47.

2. Turn on the iP47 and press the Mode button until “Bluetooth” appears in the lower part of the display .

3. Press the Play/Pause Button on the main unit or remote control to play your Blueetooth enabled device.

The display will show “Bluetooth” and Play Icon on the button line of the display. (Depending on the

Bluetooth device you are using, you may need to manual go into media player mode on your device to

make it work properly).

4. Press the Play/Pause Button again to pause play; press again to resume it.

5. Using the Raise Volume or Lower Volume on main unit or remote control to adjust the system volume..

6. Press  or  Button on main unit or remote control to go to the next or previous track.

Please remember to turn off Bluetooth device manually.

You can play an MP3 player or other portable audio device through the iP47 via the Line in Jack.

1. Plug one end of an audio patch cord (available at http//:www.ihomeaudio.com) into the headphone or

line-out jack on your device and the other end of the patch cord into the iP47 Line in Jack, located on the

back of the unit.

2. Turn on iP47 and press Mode button until “LINE IN” appears in the lower part of display, indicating Line in

playing mode.

3. Turn on and play your device.

4. Press the Raise Volume or Lower Volume Button on the iP47 or on the remote control to adjust the system

volume. You may need to adjust your device volume, too.

Remember to turn off your device when you are done playing it.