Instruction manual

Installing/Replacing the Clock Backup Battery

The iP44 requires a CR2032 lithium battery (included) to provide backup power to

the clock in the event of a temporary power interruption. The CR2032 backup

battery was packed in the same poly bag with this instruction manual.

1. Place the clock radio face down on a flat surface.

2. Slide the battery door in the direction of the arrow and then lift the door by the

opposite edge to remove it from the radio.

3. Install the CR2032 backup battery in the battery compartment with the “+” side

facing up as shown in the illustration.

4. Replace the battery door.

If AC power is interrupted the backlighting in the display will go off and the radio or

docked iPod/iPhone will not play. However, the buzzer alarm will still turn on at the

selected time to wake you up, even if you had selected the Wake to Radio, or Wake

to iPod alarm modes.

When the Battery Low Icon appears in the display it is time to replace the battery. Purchase a fresh CR2032 battery,

available wherever batteries are sold. Follow steps 1 through 4 above to remove the exhausted battery and install the fresh

battery. IMPORTANT: To avoid having to reset the time and wake up time, leave the radio connected to the AC outlet when

you install the new backup battery.

Note: Make sure you dispose of the exhausted lithium battery properly, according to your local regulations.

Installing Backup Battery

