User's Manual

Quick Start
1:Power:
AC or Batteries
1
4:Nano
P3
To dock a nano:
a) gently guide the nano onto the connector pins in the
dock
b) slide the nano insert over the docked nano
4:iPod
Insert iPod into dock with proper insert. When running
on AC power, the iPod will charge while docked. Press
the Play Button on the iH85 remote to play iPod.
2:Inserts
To charge and play iPod, attach AC adaptor cable to jack
at waist of the iH85 (under rubber tab) and plug the other
end into a working AC outlet. Does not charge batteries.
For portable operation (on bike, etc.), open the battery
door located inside the unit opposite the iPod dock.
Install 4 AA batteries (match + and - polarity in diagram).
Install iPod Insert (except nano)
Your iH85 comes with 3 inserts to ensure your
iPod fits properly in the dock located inside the
case above the Power button. Twist the case
to the right and lift to access iPod dock.
To place an insert:
1. Select the insert for your iPod if needed
(see table below). Using the correct insert
ensures the proper fit to your iPod.
2. Gently press the iPod insert into the dock.
3. Carefully place your iPod with insert into
the dock. The iPod must not be in a case
or “skin”.
NOTE: See step 3 for docking a nano
Use with
iPod Mini
iPod 4G 20 GB
iPod Photo 20/30 GB
5G iPod w/ Video 30 GB
Mini Insert
Thin iPod Insert
Thick iPod
(no Insert needed)
Nano Insert
iPod 4G 40 GB
iPod Photo 60 GB
5G iPod w/ Video 60/80 GB
iPod Nano
2/4/8 GB
A
B
Attaching the Remote Clamp and Mounting Bracket
5:Bracket
2
P4
2:Clamp
Attaching the Mounting Bracket
a) Align bracket with existing bottle
bracket holes on down tube, or
drill holes if needed.
b) Screw bracket firmly to down tube
until securely fastened
To attach the iH85, slide it into the
bracket with the Power button
facing you and the speaker facing
up.
To attach the iH85 remote, slide the mounting slot on
back of the remote down the square top of the clamp
until it clicks. Press clip button to release. Do not leave
remote on bike when unattended.
A
B
1:Mounting Clamp
A
B
C D
a) Using Philips screw driver, open mounting clamp.
b) Put two rubber mounting spacer strips together and cut to
desired length. Place mounting strip on mounting surface
(bar, handle). Add thick strip as needed.
c) Wrap mounting clamp around spacer
d) Tighten clamp using a Philips screwdriver