User's Manual

iBT4
Using the
6
P10
Playing Audio via Line-In
1. Connect one end of a standard stereo 3.5mm audio cable (not included) into the line-in jack on
the back of the unit and the other end into the headphone or output jack of your audio device.
2. Turn the Power/Mode Dial on the unit RIGHT (to any mode) to turn it on.
3. Power on the audio device and use the controls on the device to play or pause audio and navigate
tracks.
4. Turn the Volume Dial to control the system volume.
5. When done listening, turn the Power/Mode Dial to the OFF position (left) to turn the unit off.
Remember to turn off your audio device, too.
Playing Audio via Line-out
You can connect the unit to an external speaker via the Line--out jack located on the back of the unit to
expand the audio playing from the iBT4
1. Connect a 3.5 mm audio cable plug to the Line-out jack on back of the unit and connect the other
end to the line-in jack on your external speaker. Note that the line output signal is mono.
2. Turn the Power/Mode Dial RIGHT (to any mode) to turn the unit on. The audio from the iBT4 will
play from both the unit’s speaker AND from the Line-out jack.
3. Turn the Volume Dial to control the system volume. The Volume Dial does NOT affect the output
volume of the line out jack.
4. When done listening, turn the Power/Mode Dial to the OFF position (left) to turn the unit off.
Remember to turn off any connected audio device, too.
NOTE: The Line-out jack is NOT a headphone jack.