User's Manual

Listening to FM Radio

Setting up the Antenna

Extend the FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

1. Press and release the Mode Button as needed to select FM radio mode.

2. When FM mode is selected, press the – or + Button to tune the radio to a desired station. The current

radio frequency appears in the lower right part of the display. Press and hold the – or + Button for a

few seconds to scan for the next clear station.

3. To memorize a station as a preset:

A. Press the Presets Button as needed to step through the 6 presets (P1 - P6) to the number you

wish to assign, and then hold the Presets Button until the selected preset number begins flashing

in the display and 1 beep sounds.

B. Press the – or + Button to tune the radio to a desired station. Hold briefly to have the radio

autoscan/search for the next clear station.

C. Press the Presets Button to confirm the setting, two confirmation beeps will confirm the setting

and the preset number you wish to assign. Repeat steps A-C to preset up to 6 stations.

4. To listen to a preset station, press the Presets Button to choose the desired preset.

5. Press the or Button on the unit to adjust the system volume.

Using the Unit in Other Countries

Different regions of the world use different FM radio frequency steps and ranges. You will need to select

the one that matches the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA, or CHINA). The

default setting is USA; if you live in the US, you may skip this section.

1. Make sure the unit is OFF (not playing in any mode). Press and hold the Mode Button for about 5

seconds until “USA” appears in the lower right part of display and 1 beep sounds. Press and release the

– or + Button to select your region.

2. Press and release the Mode Button again (or no button within 10 seconds) to exit the radio frequency

setting mode. Two beeps will confirm radio frequency setting.

Using the

iBT280