User's Manual

iBN10

Using the

P17

Replacing and Installing Clock Backup Batteries

Note: 2 AAA batteries are included with the unit. Install them before using the unit.

This model is equipped with a battery backup circuit that will maintain the time and other settings in the event of a

temporary power interruption (the display is NOT maintained). When the backup batteries are getting weak the

Low Backup Battery Indicator will begin flashing in the display. When you see this flashing indicator you should

replace the backup batteries as soon as possible. Note: We recommend alkaline batteries for best performance.

To install/replace the backup batteries:

IMPORTANT: When replacing the backup batteries be sure to have the unit connected to the AC outlet to maintain all of your

settings, otherwise it will be necessary to reset them after the batteries are replaced.

1. Slide and remove the battery door located on the bottom of the

unit. If replacing batteries, remove the exhausted batteries.

2. Insert 2 fresh AAA batteries in the backup battery compartment.

Make sure the polarity of the batteries (“+” or “-” nodes) matches

the illustration.

3. Slide and close the battery compartment door. Confirm that the

backup battery indicator is not flashing in the display.

Note: Make sure you dispose of batteries properly (see your local regulations)

Battery Warning

• Do not heat above 75ºC (167ºF) • Do not mix old and new batteries

• Do not open batteries • Do not mix alkaline, standard (carbon-zinc),

• Do not install backwards or rechargeable (ni-cad, ni-mh, etc.) batteries

• Do not dispose of in fire

• Do not expose contents to water

- ;