Instruction Manual

For questions or help with the installation, please email
[e-mail]
Store front hours: Mon. – Fri. 8:00am – 5:30pm and Sat. 9:00am – 2:00pm Arizona Time.
Page 5 of 6
4. Preparing your Switch Pros and Mount. Align your Power Module to the SDHQ Built Mount
as shown above and use Switch Pros supplied hardware to secure the Power Module.
5. Installing the Power Module Mount. Align the rear open slot (side with the logo) on the
Power Module Mount between the fender and fender frame, as shown. Pivot the mount around
the rear slot and align the front open slot between the fender and fender frame, as shown. The
fender will need to be lifted slightly and the mount pulled towards the rear of the vehicle to
align the mount properly. Tighten the rear 10mm bolt, securing the SDHQ Built Power Module
Mount, and align the fender to original position. Clip in the hood latch wire from Step 2.
6. Installing the Power Module Mount Continued. Tighten the front 10mm fender bolt that’s
located under the driver tie down. Then place the tie down back on the vehicle and tighten the
(2) 10mm removed in step 3. Replace the final 10mm fender bolt that helps hold the tie down
and tighten. Enjoy your new SDHQ Built Power Module Mount. You can now proceed to wiring
your Switch Pros.