Instruction Manual

ManualsBrandsSDHQ ManualsModule MountSDHQ SDHQ-14-1141-G6 Ford Bronco Switch Pros Power Module Mount

Latest Revision: 7/14/2022

For questions or help with the installation, please email

help@sdhqoffroad.com

Store front hours: Mon. – Fri. 8:00am – 5:30pm and Sat. 9:00am – 2:00pm Arizona Time.

Page 1 of 6

Product Packing List

Product:

SDHQ-14-1141-G6

Description: 2021+ Ford Bronco Switch Pros Power Module

Mount

(1) SDHQ Built Ford Bronco Switch Pros PMM SDHQ-14-1141-G6

Inspected and Packaged By: Date:

Summary of content (6 pages)

PAGE 1
Latest Revision: 7/14/2022 Product Packing List Product: SDHQ-14-1141-G6 Description: 2021+ Ford Bronco Switch Pros Power Module Mount (1) SDHQ Built Ford Bronco Switch Pros PMM Inspected and Packaged By: SDHQ-14-1141-G6 Date: For questions or help with the installation, please email help@sdhqoffroad.com Store front hours: Mon. – Fri. 8:00am – 5:30pm and Sat. 9:00am – 2:00pm Arizona Time.
PAGE 2
For questions or help with the installation, please email help@sdhqoffroad.com Store front hours: Mon. – Fri. 8:00am – 5:30pm and Sat. 9:00am – 2:00pm Arizona Time.
PAGE 3
INSTALLATION INSTRUCTIONS Product: SDHQ-14-1141-G6 Description: 2021+ Ford Bronco Switch Pros Power Module Mount Parts List Hardware List Required Tools (1) SDHQ Built Ford Bronco Switch Pros PMM SDHQ-14-1141-G6 N/A 10mm Socket Ratchet Tech Notes Fits either SP-9100 OR RCR-Force-12 Power Module Mounts Utilizes Switch Pros hardware for mounting. Approx. Install Time: 1 Hour For questions or help with the installation, please email help@sdhqoffroad.com Store front hours: Mon. – Fri.
PAGE 4
***READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION! *** Installation Instructions: 1. Unbox all of your parts, gather all required tools and familiarize yourself with the parts and instructions. 2. Preparing your vehicle. Begin by opening your hood and locating the (2) bolts shown below. Using a 10mm socket and ratchet, remove the front bolt and the rear bolt. Unclip the hood latch wire from the fender frame to help with install. 3. Preparing your vehicle Continued.
PAGE 5
4. Preparing your Switch Pros and Mount. Align your Power Module to the SDHQ Built Mount as shown above and use Switch Pros supplied hardware to secure the Power Module. 5. Installing the Power Module Mount. Align the rear open slot (side with the logo) on the Power Module Mount between the fender and fender frame, as shown. Pivot the mount around the rear slot and align the front open slot between the fender and fender frame, as shown.
PAGE 6
Wiring: Once the Switch-Pros power module is mounted, but BEFORE it is connected to anything else, do the following: 1. Reinstall battery (if battery was removed during installation), and secure factory connections. Start vehicle and confirm that battery is properly installed, connected and grounded. 2. Connect the Switch-Pros Ground wire lug to the negative terminal on the battery (grounding elsewhere will not properly filter noise and will void your product warranty). 3.