Instruction Manual

P:\INST INSTRUCTIONS\Accessories\INST-WRC Rev B 10-20 Page 2
Operation & Typical Wiring
Manual (M) (default) – Pressing remote button “A” activates relay “1”. Relay “1” remains active only
while remote button “A” is pressed; Pressing remote button “B” activates relay “2”. Relay “2” remains
active only while remote button “B” is pressed.
Latching (L)– Pressing either remote button activates its respective relay. The relay remains active until
the other remote button is pressed, activating its respective relay.
Timed (3s) – Remote button “A” activates relay “1” for 3 seconds (fixed); remote button “B” activates
relay “2” for 3 seconds (fixed). Both relays may be activated simultaneously.
Toggle (Jumper OFF) – Pressing remote button “A” activates relay “1”. Relay “1” remains active until
remote button “1” is pressed again; Pressing remote button “B” activates relay “2”. Relay “2” remains
active until remote button “B” is pressed again. Both relays may be activated simultaneously.
OPERATIONAL MODES – 4 available modes; select using on-board Configuration Jumpers (NOTE: Receiver cover will
need to be removed by carefully using a small phillips screwdriver to remove the two screws on the back of the unit.
Be careful not to strip or overtighten the screws)
Prog.
Status
LED
Wiring Pigtail
Connector
Learning
Button
RED (+VDC)
BLK (GND)
GRN (Relay 1 – N/C)
ORG (Relay 1 – Com)
YEL (Relay 1 – N/O)
}
WHT (Relay 2 – N/C)
BLU (Relay 2 – Com)
VIO (Relay 2 – N/O)
Relay 1Relay 2
C B A C B A
+ (-)
M
L
Setting
Mode Description
1. Power the receiver using the appropriate power source.
2. Press the Learning Button for 1 sec., then release (LED will light while pressed)
3. Within 30 seconds, press & hold the “A” or “B” on the transmitter, until the Status LED on the Receiver starts
flashing, then release.
The transmitter is now added to the receiver. To Activate, hold “A” or “B” button for 1 sec (the blue LED on the
transmitter will light).
To delete all transmitters from the receiver, press & hold the learning button for 7 secs., until the status led turns off.
PROGRAMMING A TRANSMITTER:
Power
Source
(See Note 1)
+(-)
FAIL
SECURE
LOCK
+
-
FAIL
SAFE
LOCK
+
-
*
*
*NOTES:
1. Use an appropriate power supply depending on your specific
receiver model. Model WRC-R2 requires a 24VDC source.
Model WRC-R2-12 must use a 12VDC source.
2. Refer to manufacturer’s installation instructions for lock
wiring. Locks shown must be the same voltage as the power
supply output.
Pwr In
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: [e-mail] ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011