User's Manual

CHAPTER 6. CHECK STRIP TEST
1. Check Strip Test
The check strip test is used to check that the analyzer is working well.
2. When to use the Lipid and Glucose check strip
• Whenever you suspect the meter does not function properly
• Before using your analyzer for the first time
• If you have dropped the analyzer
• If the analyzer has not been used for a long time
CAUTION: The check strip test does not replace the control solution test.
3. How to Use the SD Lipid Check Strip
1) To enter the Checking mode of the lipid check strip, press both the left and right buttons
together at the strip standby mode, and hold for 3 seconds. Then, the CHE message will
appear on the screen.
2) Insert the SD Lipid Check Strip into the lipid strip slot of the analyzer.
3) The check strip result appears on the screen after 10 seconds. If there is no problem with
the analyzer, the OK message will appear on the screen. Otherwise, if there is a problem
with the analyzer, the EEE error message will appear on the screen.
NOTE: If you get the EEE error message, please try to perform a check strip test again. If it
keeps displaying the EEE error message, please contact our customer service center at 1-
855-486-2888.
- 44 -