User's Manual
Table Of Contents
- CHAPTER 1. Understanding THE New Analyzer
- CHAPTER 2. Using the SD LipidoCare Professional Analyzer
- CHAPTER 3. Collecting blood samples
- CHAPTER 4. Performing a test for lipid or glucose
- CHAPTER 5. Control Solution Test
- CHAPTER 6. CHECK strip Test
- CHAPTER 7. Maintenance and Troubleshooting
- CHAPTER 8. Screen Message and Troubleshooting
- CHAPTER 9. Warnings, Precautions, and Limitations
- CHAPTER 10. Technical Information
- Appendix 1: References
- Appendix 2: Warning
2. Test Procedure for cholesterol (lipid) only
1) Prepare a lipid test strip for the measurement.
2) Hold the lipid test strip with thumb and index finger so that the lipid test strip is facing
upward.
3) Insert the lipid test strip into the lipid test strip slot of the analyzer. When the lipid test strip
reaches the correct position, you will hear a beep.
4) After the display appears, open the door by lifting it. Then, the display below will appear.
5) Prepare the blood samples collected from your fingerstick.
NOTE:
• For the procedure to collect the capillary whole blood from your fingerstick, please refer
to Chapter 3. Collecting Blood Samples.
• To measure the lipid, the capillary whole blood from your fingerstick is the only option.
Do not use a blood sample from an alternative site.
6) Apply the collected sample to the sample application area of the lipid test strip.
- 33 -