ASTRA 777 Mobile VEHICLE SECURITY SYSTEM PRODUCT MANUAL
Limited Lifetime Warranty This vehicle security system is warranted to the original purchaser, to be free from defects in material and workmanship. The manufacturer will repair or replace at its option, and free of charge for the first twelve (12) months, any part that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to the manufacturer freight prepaid.
Table of Contents
About Your System Congratulations on your purchase of this state-of-the-art vehicle security system from ScyTek Electronics. With proper installation this system will provide superior protection and performance for many years to come.
Quck Start Guide for Astra Mobile System Registration: To Register your Astra 777 Mobile: Login on to www.scytrak.
New Master Account Registration Page New Master Account Registration screen. In the “User ID” area type in your login ID, then complete the rest of the information. After completing Master Account registration page, click on “O.K” at the bottom far right side.
New Vehicle Registration Page New Vehicle Registration screen In the “Vehicle’s ID ” area type in the Vehicle name such as Johny’s Car or Vehicl’s model, then complete the rest of the information.
Billing Information Page Billing information screen. In the Service Term Area, select the yearly plan that you like. then complete the rest of the information.
Sub User Page Subuser account allowes for additional users to manage the fleet vehicles with varies degrees of control. Click on Subuser Management to edit the page. Register the sub user and assign the vehicles and checkmark the desired privilege of the user. More then one sub user can be assigned to that vehicle group.
Astra Mobile Page login page www.scytrak.net Astra 777 Mobile GPS Login Page: Login: input your Login ID and your Password. “you may changeyour password at any time for your personal security” Click on the field marked “Sign in” and you will then be taken to your Astra 777 Mobile GPS Home Page.
Home Page Your Astra 777 Mobile GPS Home Page will have your vehicle(s) listed and look very similar to this. Click on the Vehicle name to select that particular vehicle, the screen will refresh displaying the map with the breadcrumb trail showing the last locations of the vehicle.
Vehicle Alert Page Vehicle Alert Window: Vehicle alert window is located bellow the map, it contains; Number of events displayed on the map Select the number of events on the map by selecting 1, 10, 40 of 80, recorded events will be displyed showing the state of the vehicle and tthe dirction of the motion. Contract expiration date Current state of the subscrption. Current alert state alrerts that are enabled are hilighted. Edit the alert selection by clicking on any of Alert buttons.
System Alerts 1. Geo Fence Alert setup: Type in the address of the Geo Fence window and the boundary size, chose if alert is for antry into or exit from the boundaries. Select the Geo Fence Alert. 2. Time Fence Alert: Set the time alert window, when alert is on, if the vehicle ignition is turned on within the time window an alert will be set. 3. Speed Alert: Select the speed threshold, when the alert is set, if the vehicle speed exeeds the set speed Alert is set. 4.
Astra Mobile Home Page In the main Page provides tracking and control of the vehicles.View all vehicle locations on the map by checking the Check all box and clicking on the Track Today/Refresh button. Refresh location manually by clicking on the Track button of the specific vehicle. When sucess result appears the map will refresh automatically and diplay the latest vahicle location.
Outputs SkyTrak system has been provided with four outputs. The system is designed for stand alone use or with combination of ScyTek Security systems. Using with combination of ScyTek Security Output 3 - Arms or Disarms the Security System Output 4 - Not Used Output 1 - Trunk Release Output 2 - Momentary activation of auxiliary output Stand Alone Mode: Output 1 and 2 are momentary, and output 3 and 4 are latched. Activate each of the outputs by pressing the output button.
Landmark Management Page From the vehicle history table click on the set button in Landmark column, the landmark window will open up. Select the appropriate icon and name the landmark. The icon will appear on the map for easy vehicle location identification.
� ���� ����� Smart Phone Smart Phone features: Arm/Disarm Trunk Release 2 way confirmation GPS Tracking Alert notification via SMS and Email Control multiple cars Login using your smart phone to: www.skytrakmobile.com Login Page Login using user ID and password.
� ���� ����� Smart Phone Vehicle Control Page �� 12 � 1 � 3 � 6 � 7 � 8 � �9� 1� 0 � 11 1 Arm and Lock 2 Disarm and Unlock 3 Trunk Release 4 Remote Engine Start (Not Used) 5 Remote Engine Stop (Not Used) 6 Locate Vehicle on the map 7 Request vehicle GPS location and system status 8 Refresh screen 9 List event history 10 Select Vehicle 11 Log Off 12 Security system status 13 Remote start status �� 13 � 2 � 4 � 5 Page 15 - Astra 777 Mobile
Smart Phone Vehicle event history page Vehicle GPS Location The main unit can be mounted under the dashboard. The GSM/GPRS antenna affixes to the windshield with the double sided tape. The GSM can be hidden under the dashboard.
Optional 2-way LCD Remote Transmitter Description Button 1 Button 2 Button 3 Button 4 Button 5 The Astra’s 777 Mobile 2-way LCD remote transmitter is offering increased range and confirmation of any activated feature. Page 1 Button 1 Arms and Locks* the system and when held for 5 seconds, activates the system’s Panic feature. Button 1 also locks the doors when the system is in Valet Mode. Button 2 Disarms and Unlocks* the system.
Adding/Replacing 2-way Optional LCD Transmitters (2 LCD remotes maximum) When adding an optional 2-way LCD transmitter to the system, follow these steps: Turn on the ignition key On, Off, On, Off, On, Off, and back On. (Key On 4 times) The siren will chirp 4 times. Press and hold the Override switch for 5 seconds. The siren will chirp 4 times. The LED will illuminate. Press Button 1 on the first transmitter, then on the second transmitter. The siren will chirp once for each transmitter learned.
· The remote will beep 3 times to indicate the alarm clock has been set. To disable the alarm clocfunction: Press and hold Buttons 2 and 3 until the remote beeps three times. · The alarm clock bell and three bars will be shown indicating alarm clock set mode is entered. Press Button 1 to disable the alarm clock. · The remote will beep 3 times to indicate the alarm clock has been disabled.
Release Button 5. · The transmitter will beep once. · The LCD panel will beep five times if enabled or vibrate and display “off” if the confirmation tones are disabled. VLT Valet mode function sets and resets the security system valet mode. * this function is enabled only when the security system is disarmed Set or reset the Valet mode: Press and hold Button 6 until the display shows VLT. · The transmitter will beep six times. Release Button 5.
Remote Transmitters Button 1 Button 3 Button 2 Button 5 Button 4 Remote Transmitter Description The Astra 777 Mobile is supplied with one 5-button Remote Transmitter used to control system operations. Button 1 Arms and Locks* the system and when held for 5 seconds, activates the system’s Panic feature. Button 1 also locks the doors when the system is in Valet Mode. Button 2 Disarms and Unlocks* the system. Pressing Button 2 again operates the Passenger Unlock feature (if installed).
Adding/Replacing One-Way Transmitters To replace lost or stolen transmitters or to add additional transmitters into the system, have all desired transmitters ready and follow the steps below. Note: Up to 4 one-way transmitters can be programmed to operate the system. Any previously stored transmitter code will be erased if it is not programed within the following sequence. To program the transmitter(s): 1. Turn on the ignition key On, Off, On, Off, and back On. · The siren will chirp 3 times. 2.
System Operation Remote Arming The system monitors 4 independent areas (zones) while armed: doors, hood/trunk, shock sensor and optional sensor input. To Arm the System: 1 Turn off the ignition. 2 Press Button 1. · The siren will chirp once.* · The doors will lock. · The parking lights will flash once. · The LED will turn on, to indicate the starter defeat is activated. 3 5 seconds after Arming: · The LED will start blinking to indicate that the doors and hood/trunk inputs are being monitored.
Tamper Alert If the system was triggered while away, the LED will flash to indicate which zone triggered the system after disarming and turning on the ignition. The LED indication will repeat 8 times.
Panic Mode In the event of an emergency, the transmitter’s remote Panic feature can be used to instantly trigger the alarm. To activate the Panic Mode: 1. Press and hold Button 1 for 5 seconds. · The alarm will sound. · The parking lights will flash. · The doors will unlock* allowing access to the vehicle. 2. Press Button 2 to stop Panic Mode. * If the ignition is on when the Panic feature is activated, the doors will lock for personal safety.
6. Turn off the ignition then arm the system. 7. Disarm the system using the new Override Code to permanently store the new code. Note: If the code set procedure is not properly performed, turn off the ignition and begin again. The override code will not be permanently stored until the code is used to disarm the system. Automatic Rearming The Automatic Rearming feature is designed to protect the vehicle in the event the system is accidentally disarmed.
Extended Features Auxiliary Function Outputs The Astra 777 Mobile system is equipped with 2 Auxiliary Outputs allowing the convenience features of the system to be further expanded. These outputs can be used to add a number of optional features such as: power trunk release, remote engine start, power window activation, power sunroof control, and more.
System Intallation 1. Thoroughly read and become familiar with the installation instructions before beginning the installation. 2. Review system contents: Main Unit 2 One-Way 5-Button Remote Transmitter Siren Shock Sensor Harnesses Receiver Antenna 14-Pin main harness 4-Pin shock sensor harness 3-Pin door lock harness LED harness Valet Switch harness Receiver Harness 3. Verify with the owner, the mounting locations for all visible components, including the LED and Override switch. 4.
Mounting the Control Unit The control unit must only be mounted in the interior of the vehicle. Do not mount the main unit in the engine compartment. Choose a mounting location that will not be easily accessible to a thief, and will not interfere with the operation of any vehicle components such as foot pedals, steering column, air vents, seat rails, etc. Do not mount the control unit until after setting the internal jumpers and performing a complete operation check of the system.
S y s t e m Wi r i n g 14-Pin Main Harness Pin 1 RED WIRE: +12V Battery Input (15A Fuse). The RED wire must be connected to a clean source of continuous +12V power. Pin 2 WHITE WIRE: Parking Light Output (+/-) relay. Connect the White wire to the circuit that shows +12V or ground only when the parking lights are on and set the internal parking light relay jumper to the proper polarity. For parking light circuits exceeding 10 amps, a relay is required.
Plug-in Connectors 3-Pin White Door Lock Connector: Plug-in connector port for door lock harness or optional door lock relay module. · BLUE WIRE - negative unlock output (-) 500mA. · GREEN WIRE - negative lock output (-) 500mA. 2-Pin Red Connector: Plug-in connector port for LED. Mount the LED in an area where it may be easily seen from either side of the vehicle. 2-Pin Blue Connector: Plug-in connector port for valet switch.
System Programing Entering System Programming To enter System Programming: 1. Turn on ignition. 2. Within 5 seconds, press the valet switch 5 times. · The siren will provide three chirps, indicating that you have entered Programming. · LED Blinks if GPS location is estableshed, LED is ON if not. 3. Press the valet switch the number times equal to the System Option you want to change. · The siren will chirp each time the valet switch is pressed. 4.
ture must be connected. (See Two Stage Door Lock Diagrams) 6. Ignore Open Door Report. Bypasses the open zone warning chirps for vehicles equipped with a residual dome light circuit that remains ON for a period of time after closing the door. 7. Auto Rearming Mode. When selected, the system will automatically re-arm and lock 30 seconds after it has been disarmed regardless if a door is open or closed. 8. Door Unlock Pulse. Selects between one pulse or two pulse operation for the door unlock output.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Brunch Feature Button 1 (default) Button 2 Button 3 Horn Chirps w/ Arm&Disarm Normal Horn Chirps Arm Mode Manual Arming Passive Arming Passive Door Locking Disabled Enabled Ignition Controlled Locks On Off Set Override Code Ignition Controlled Unlock All Driver Only Disabled Ignore Open Door Report Off Ignore Auto Rearming Disabled Enabled Door Unlock Pulse Single Double Arming Chirps Normal Silent Disarm with Aux 1 Disabled Enabled Door Lock Pulse L
Door Lock Diagrams Follow the diagrams below for connecting basic door lock systems. For Two Stage door lock systems (separately unlocks driver and passenger doors) see following pages.
Two Stage Door Lock Diagrams The Astra 777 Mobile is equipped with a dedicated Passenger Unlock output allowing Two Stage Door Lock operation. When connected as shown below, disarming the system will unlock only the driver’s door. Pressing the disarm button again will unlock all doors.
Two Stage Reverse Polarity Two Stage Adding Actuators Page 37 - Astra 777 Mobile
Technical Information FCC ID: OARRXAM2000 This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference.
Page 39 - Astra 777 Mobile
Wi r i n g D i a g r a m Astra 777 Mobile Shock Sensor Grren (-) Lock ouput not used Blue (-) Unlock ouput Red +12V White Parking light output (+) 7A Brown Siren output (+) Blue/White Passenger unlock output (-)500ma White/Red Auxiliary 2 output (-)500ma Orange Armed output (-)500ma Brown/White Horn output (-)500ma Black/White Dome Light output (-)500ma Blue Hood/Trunk input(-) Gray Auxiliary 1 output (-)500ma Yellow Ignition Input +12V Black Ground Input Violet Door Trigger input (+) Green Door Trigger i
