Product manual

Precision Blue - Page 3
Entering System Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
· The Horn will provide three chirps, indicating that you have entered Programming.
3. Press the valet switch the number times equal to the System Option you want to change.
· The siren will chirp each time the valet switch is pressed.
4. Within 5 seconds, turn ignition OFF and ON corresponding to the desired operating mode for
that System Option.
· The Horn will Honk to indicate the setting.
1 Honk = Ignition OFF/ON 1 Time
2 Honks = Ignition OFF/ON 2 Times
3 Honks = Ignition OFF/ON 3 Times
5. When you are finished, turn off the ignition to save the changes.
Default Reset
Following this procedure will set all Programmable System Options to factory default settings.
1. Enter System Programming.
2. Turn The Ignition OFF/On 3 Times.
· The siren will chirp 6 times indicating that the reset signal was received.
· All Programmable System Options are now set to factory default settings.
· The Valet Mode is off.
3. Turn off ignition.
Resedence valet (Home Garage)
1. with ignition in Off position Press Valet switch 3 times
2- LED will start flashing once every 5 seconds doors will not lock automaticaly
until ignition turns on and off again.
Drive off valet
1. with ignition in On position Press Valet switch 3 times
2- LED will flash once.
3- when ignition turns back to Off position the LED will flash rapidly and doors will lock automaticaly.
at this time the Bluetooth Phone will be ignored until ignition is turned On again.