ASTRA 1000RS SERIES AUTOMATIC/MANUAL TRANSMISSION WITH SEPERATE LOCK/UNLOCK BUTTONS REMOTE START SYSTEM PRODUCT MANUAL
Limited Lifetime Warranty This vehicle starting system is warranted to the original purchaser, to be free from defects in material and workmanship. The manufacturer will repair or replace at its option, and free of charge for the first twelve (12) months, any part that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to the manufacturer freight prepaid.
Table of Contents 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 14. 15. About Your System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 1 Remote Transmitters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Remote Transmitter Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Adding/Replacing Transmitters . . . . . . . . . . . . . . . .
About Your System The Astra 1000RS Series is a state-of-the-art remote starting system with an integrated 2-way paging feature. With proper installation, this system will provide superior protection and performance for many years to come.
Remote Transmitters Remote Transmitter Description LED Button 1 Button 2 Button 5 Button 3 Button 4 Depending on the model chosen, the Astra 1000RS Series will be supplied with one or two 5-button Remote Transmitters that are used to control the system’s operations. Button 1 Locks the doors and when held for 5 seconds, activates the system’s Car locator feature. Button 2 Unlocks the doors. Button 3 Activates the Auxiliary 1 output. This output can be programmed for customization.
3. Press Button 1 on the first transmitter. · The parking lights will flash once. 4. Press Button 1 on the first transmitter again. · The parking lights will flash twice to indicate it has learned the code. 5. Repeat steps 3 and 4 for each transmitter (up to 4). 6. Turn off the ignition key. · The parking lights will flash 3 times. To program 2-way LCD transmitter(s): 1. Turn the ignition key On, Off, On, Off, On, Off and back On· .The parking lights will flash 4 times. 2.
Optional 2-way LCD Remote Transmitter Description Button 1 Button 2 Button 3 Button 4 Button 5 The Astra 1000RS-2W-1 is supplied with one 2-way LCD remote transmitter, offering increased range and confirmation of any activated features. Button 1 Locks the system and when held for 5 seconds, activates the system’s Car locator feature. ·Also locks the doors when the system is in Valet Mode. Button 2 Unlocks the system.
LCD Transmitter Battery Replacement Your Astra Remote Transmitter uses a 1.5 volt AAA alkaline battery, which will require replacement in time. Depending on the amount of use, the battery may last up to three months before it needs replacement. When the battery needs replacing, the system’s operating range will decrease, the LCD display will show only one of three bars in the battery icon, or the display and sounds may suddenly stop and start as the battery voltage drops below minimum.
4. When the desired time is displayed, press Button 5 to store. · The remote will play a melody to indicate the alarm clock has been set. To disable the automatic start / auto activate function: 1. Press and hold Buttons 2 and 3 until the remote beeps four times. · The fan and clock will be shown indicating automatic start mode is entered. 2. Press Button 1 to disable the alarm clock. · The remote will play a melody to indicate the alarm clock has been disabled.
Transmitter Icon Description Some of the features in the LCD’s Icon Description page are not Available on the 1000RS Series.
System Operation Remote Locking To Lock the doors: 1. Turn off the ignition. 2. Press Button 1. · The doors will lock. · The parking lights will flash once. · The LED will turn on, to indicate the doors are locked. 3. 10 seconds after Locking: · The LED will start blinking as a theft deterrent and the Optional Starter Kill will activate. Remote Unlocking To Unlock the doors: Press Button 2. · The doors will unlock. · The parking lights will flash twice.
Remote Start Features Manual/Automatic Transmission Mode The Astra 1000RS Series is designed to be used in vehicles with automatic transmission only. Astra 1000RS-M is designed to be used in vehicles with manual transmission only.
Shut Down When the the Remote Start feature is active, any of the following actions will shutdown the engine: 1. Pressing Button 4 · After the engine shuts down the doors will lock (programmable) 2. Pressing the Brake Pedal. 3. Opening the Hood. 4. Remote Start Time-Out (completion of the timed run cycle). Quick Stop (Automatic Transmission Only) The Quick Stop Feature allows you to exit the vehicle while keeping the engine running for quick stops. To leave the vehicle running: 1. Press Button 4 . 2.
Extended Features Ignition Door Locking For added safety, the Ignition Door Locking feature allows vehicles equipped with power door lock systems to automatically lock the doors when the ignition is turned on. If a door is open when the ignition is turned on, the Ignition Door Locking feature is disabled to protect against locking the keys inside the vehicle. Ignition Door Unlocking For added convenience, this feature automatically unlocks the doors after the ignition key is turned off.
System Installation 1. 2. Thoroughly read and become familiar with the installation instructions before beginning the installation. Review system contents: Main Unit Two 5-Button 1-Way Remote Transmitters (1000RS Series) One 5-Button 1-Way Remote and One Two-Way LCD Remote Transmitter (1000RS-2W-1 Series) • 16-Pin main harness • 3-Pin door lock harness • 2-Pin LED harness • 2-Pin Override Switch harness • Relay Pack 3.
System Wiring 5-Pin Harness Pin 1 Pin 2 Pin 3 pin 4 pin 5 ORANGE WIRE: Accessory Output for heater/air conditioner(negative) to activate external relay YELLOW WIRE: Ignition 1 output (negative) to activate external relay. VIOLET WIRE: Starter Output (negative) to activate external relay BROWN WIRE: Ignition 2 output (negative) to activate external relay. RED WIRE: +12V Power to external relays. 16-Pin Main Harness Pin 1 BROWN/WHITE: Horn Output (-) 500 mA.
the proper polarity. For parking light circuits exceeding 10 amps, a relay is required. For vehicle’s with independent left and right parking light circuits, diodes must be installed to keep the circuits separate. NOTE: Do not connect the WHITE wire to the vehicle’s headlight circuit. Pin 16 RED WIRE: Module Power Input (+). Connect to a constant source of +12V. 2-Pin Blue Connector: Valet switch port. Mount switch where it is accessible from the driver’s position. 2-Pin Red Connector: LED port.
Jumper Settings Jumper Selection Carefully separate the top and bottom halves of the main unit case. Once the cover is removed, the parking light polarity jumper will be visible next to the parking light relay. Set the jumper for the correct polarity output as described below, then reassemble the main unit case. Parking Light Output. Selects the polarity (+/-) for the output of the on-board Parking Light relay.
System Programming Entering System Programming To enter System Programming: 1. Turn on ignition. 2. Within 5 seconds, press the valet switch 5 times. · The parking lights will flash three (3) times indicating you have entered Programming. 3. Press the valet switch the number times equal to the System Parameter you want to change. · The parking lights will flash each time the valet switch is pressed. 4.
6. 7. 8. 9. 10. 11. 12. 13. 14. Momentary operation provides an output for as long as the transmitter button is pressed. Timed operation provides an output that turns on for 10 seconds each time the transmitter button is pressed. If the button is pressed again during the 10 seconds, the output will turn off. Latched operation provides an output that turns on when the transmitter button is pressed and remains on until the transmitter button is pressed again. Unlock with Aux 1.
Branch Feature 1. Ignition Door Locking 2. Ignition Door Unlocking 3. Door Unlock Pulse 4. Door Lock Pulse Length 5. Aux 1 Mode 6. Unlock with Aux 1 7. Start in Valet Mode 8. Lock after Start 9. Lock after Shutdown 10. Engine Run Time 11. Automatic Start Mode 12. Tachless Sense Crank Time 13. Engine Type 14. Ignition 2 Output Program 15. Turbo/Manual Transmission Start 16. Unlock Before Start 17. Interior Light/Rearm Mode 18. Smart Start Run Monitor 19. Key-Less Entry Chirp 20. Remote Start Confirmation 21.
Door Lock Diagrams Follow the diagrams below for connecting basic door lock systems. For Two Stage door lock systems (separately unlocks driver and passenger doors) see following pages.
Technical Information FCC ID: OARRXAM2000 This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference.
Notes: Astra 1000RS Series - Page 21
Notes: Page 22 - Astra 1000RS Series
Notes: LED Light Call/Valet/Override Switch Valet/Override Switch LED Light RS Series RS-2W Series Astra 1000RS Series - Page 23
Wiring Diagram WHITE - Parking Brake Input (-) BLUE - Auxiliary start activation Input (-) Green - Lock Out (-) 500ma N.A.
