Scyan X7 Fingerprint Keypad Lock User Guide -1-
Contents I. Programming code ------------------------------------------------------------------------4 1. Fingerprint user enrollment --------------------------------------------------------------- 5 2. Unlock using a fingerprint ---------------------------------------------------------------- 5 3. Delete a single fingerprint ---------------------------------------------------------------- 5 4. Delete all fingerprints --------------------------------------------------------------------- 6 5.
Thank you for choosing Scyan X-7 fingerprint keypad lock. No more worries about losing your keys! The X-7 lock offers a convenient and secure lock system solution that adopts the latest and most advanced fingerprint lock technologies. The lock has selflearning ability, which enables the lock to update a user fingerprint template after every fingerprint entry. This unique feature significantly reduces rejection rate when compared to other fingerprint lock systems on the market.
Key override feature could be disabled. 9V battery may be attached as an additional power source. Double-shell heavy duty construction design. Low power alert. Specifications: Optical sensor. Standard 12-key keypad. Tubular latch. Adjustable backset 2 ⅜” or 2 ¾”. Fit door thickness between 1 ¼” and 2 ¼” (Order screws for door thickness between 2 ¼” and 2 ½”). Operation temperature from -4°F to 150°F (-20°C to 65°C). Powered by 4 AA Alkaline batteries (NOT included).
enter the default programming code, then press # enter a new programming code (any combination of 4-12 digits), then press * enter new programming code, then press # If changing the programming code is successful, you will hear one long beep and the keypad will show blue light. Otherwise, you will hear two short beeps and the keypad will show red light. Repeat the above steps as necessary. Fingerprint User The lock is capable of storing up to100 user fingerprints.
rejections, the system will shut off. You need to lift your finger at least 2 inches away from the sensor, then place finger back on sensor to re-active the sensor 3. Delete a single fingerprint: 3.1. Login using Programming code or an administrator fingerprint. Press * then enter Programming code, followed by pressing #, or Press * followed by placing an administrator fingerprint on the sensor. If login is successful, you will hear one long beep and the keypad will show blue light.
Enter user code on keypad then press #. When you press the first number of the user code, press and hold the first number key until you hear a beep and the keypad shows blue light. If the user code is authenticated, you will hear one long beep and the keypad will show blue light. The lock will unlock. Otherwise, you will hear two short beeps and the keypad will show red light. 7. Delete a single user code: 7.1. Login using Programming code or an administrator fingerprint.
13. System reset: The system can be reset to the factory-set default mode by pressing the reset button. To reset the system, press the reset button and hold until you hear a long beep. The reset button is located on the PCB board. If you’ve already installed the lock onto a door, you will need to take the lock off the door in order to locate the reset button. After resetting the system, Programming Code will revert back to the default programming code (123456).
Product return: Please refer installation instruction 8 on page 8 to removal and disassemble lock, then refer the following diagram to pack lock. Customer Service: USA: 1-800-610-8708 International: 1-206-659-8006 Email: info@scyanelectronics.com www.scyanelectronics.
