User manual

9.2.4 Configuring SNMP
Purpose:
You can use SNMP protocol to get device status and parameters related information.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the SNMP tab to enter the SNMP Settings interface.
Figure 9.14 SNMP Settings Interface
3. Check the SNMP checkbox to enable this feature.
4. Configure the SNMP settings.
Figure 9.15 Configure SNMP Settings
5. Click the Apply button to save and exit the interface.
Note: Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the device is allowed to send the alarm event and
exception message to the surveillance center.
9.2.5 Configuring UPnP™
Purpose:
UPnP™canpermitsthedeviceseamlesslydiscoverthepresenceofothernetworkdevicesonthenetworkand
establishfunctionalnetworkservicesfordatasharing,communications,etc.IfyouwanttousetheUPnP™
function to enable the fast connection of thedevicetotheWANviaarouter,youshouldconfiguretheUPnP™
parameters of the device.
Before you start:
IfyouwanttoenabletheUPnP™functionofthedevice,youmustenabletheUPnP™functionoftherouter
to which your device is connected. When the network working mode of the device is set as multi-address, the
123